Building 66041 Repair Lab 103B and Dome, KAFB

This action was awarded as an 8(a) Sole Source Set-Aside under the authority of section 8(a) of the Small Business Act. The contractor shall furnish all parts, material, labor, equipment and supervision necessary to complete the work for Building 66041 Repair Lab 103B and Dome 102. The work shall include the following requirements listed in the specific requirements. The contractor shall assure the attached waste summary checklist and DD Form 1354 are completed within three (3) working days of “place in service date” and submitted to USACE and Kirtland AFB Real Property office to get it staffed to the BCE for signature, at the conclusion of the project. 2. SPECIFIC REQUIREMENTS: Demolition Contractor must remove abandoned conduit and j-boxes, as indicated on the Not For Construction drawings. Contractor must remove abandoned A/C unit, as indicated on the Not For Construction drawings. Contractor must remove existing insulation, as indicated on the Not For Construction drawings. Contractor must remove existing door hardware, as indicated on the Not For Construction drawings. Contractor must remove existing motion sensor and ceiling tile, as indicated on the Not For Construction drawings. Contractor must remove existing badge reader, as indicated on the Not For Construction drawings. Construction Contractor must repair, float, texture and paint existing wall, as indicated on the Not For Construction drawings. Contractor must provide and install new door hardware, as indicated on the Not For Construction drawings. Contractor must provide and install new gyp. bd., as indicated on the Not For Construction drawings. Contractor must provide and install new man bars, viewport and dielectric break on existing duct work, as indicated on the Not For Construction drawings. Contractor must seal all penetrations and ground existing conduit, as indicated on the Not For Construction drawings. Contractor must secure existing hatches, as indicated on the Not For Construction drawings. Contractor must replace existing gutter, as indicated on the Not For Construction drawings. Contractor must provide and install new insulation, as indicated on the Not For Construction drawings. Contractor must patch existing wall, as indicated on the Not For Construction drawings.