Repair Elevator F200

The existing elevator at F200 is a Kone brand MRL (Machine Room-Less) traction elevator designed without a machinery space or a machine room to house the mechanical equipment for powering the elevator. Vance AFB is seeking proposals to replace this existing elevator with a new 2500lb capacity, direct plunger, non-telescoping, non-inverted cylinder, in-ground hydraulic elevator with front and rear doors. Elevator speed shall meet or exceed 80ft per minute. Controller shall have onboard diagnostic tool. First floor doors will be one speed side sliding left hand, and second floor doors will be one speed side sliding right hand doors. The elevator brand and specifically the model has been pre-screened and found to meet UFC 03-490-06: Elevators issued 08 June 2018. Specifically bids for a single non-inverted, non-telescoping in ground plunger design shall be accepted for review. Additional building work is required as a part of this project, and shall be part of the successful bid. Specifically, this project will require selective demolition of the existing rough opening and removal of the existing cab and operating mechanisms including all existing mechanical equipment. Additionally, wall framing for a new machine room and adjacent storage closet will occur in an existing office. Framing of two new doors to access the new mechanical room and the existing office. Contract to include submittal of construction drawings for the enclosure of the required mechanical room and all framing and finishing associated with the elevator shaft. Work shall occur in accordance with all state and federal laws and meet all required OSHA standards for worker protections. Unless otherwise noted, all code requirements shall be assumed to be the most current published. Variations to this statement will be proceeded by the word “VARIATION:”. The performance period for this project shall be 210 days.