35 -- 400-550 LB STEAM INDUSTRIAL DRYER

DRYER SHALL BE STEAM HEATED INDUSTRIAL DRYER. 400-550 LB DRY WEIGHT CAPACITY, THE BASKET SHALL HAVE VOLUME OF 155 CU. FT. 78 INCHES MINIMUM INSIDE BASKET DIAMETER AND SHALL BE CONSTRUCTED OF 10 GAUGE PERFORATED METAL 2 1/2 INCHES PERFORATIONS, DRYER BASKET SHALL SHALL NOT BE DRIVEN BY A TRUNNION SHAFT OR BY FRICTION WHEELS, ONE DOOR, TWO WAY TILT, FRAMEWORK SHALL BE CONSTRUCTED OF MINIMUM 3/16 INCH STEEL, 25 HP EXHAUST BLOWER WITH MIMIMUN AIR FLOW OF 11,000 CFM. VOLTAGE 208/60/3. DRYER SHALL BE CONTROLLED BY A MICROPROCESSOR OR A PROGRAMMABLE LOGIC CONTROLLER WITH CAPABILITY OF STORING NO FEWER THAN FORTY (40) DRYING PROGRAMS. DRYING PROGRAMS SHALL ALLOW FOR DRYING BY EITHER INLET OR OUTLET TEMPERATURE AS WELL AS COOL DOWN BY TIME OR TEMPERATURE. DRYER SHALL INCLUDE AUTOMATIC FIRE SUPPRESSIONS SYSTEM. ADDITIONALLY ACTIVATION, AS WELL AS A MANUAL VALVE TO ACTUATE FIRE SUPPRESSION SYSTEM IN CASE OF POWER FAILURE. PUSHING E-STOP BUTTON DOES NOT INTERRUPT POWER TO FIRE SUPPRESSION SYSTEM, DRYER SHALL BE FACTORY MUTUAL APPROVED OR U/L LISTED, SHALL INCLUDE A STAINLESS STEEL DRY LINT COLLECTOR BUILT ONTO AND INTEGRATED WITH DRYWER INCLUDING INTEGRAL AIR RECEIVER FOR END-OF-CYCLE LINT BLOW DOWN. THERE SHALL BE A SEPARATE LINT COLLECTOR, AUTOMATIC FIRE SAFETY SUPPRESSION SYSTEM WITH ALARM, BUT NO SEPARATE UTILITY CONNECTIONS TO LINT COLLECTOR SHALL BE REQUIRED, AND THE TRANSITION TO LINT COLLECTOR SHALL BE FACTORY INSTALLED. PROJECT TO INCLUDE TRAPS AND VALVES. HEIGHT FROM FLOOR TO BOTTOM OF BASKET DOOR IN LOAD POSITION SHALL NOT EXCEED 59 INCHES. DRYER SHALL INCLUDE ALL OF THE FOLLOWING INTERLOCKS, SAFETY DEVICES AND OTHER FEATURES: AUTOMATIC FIRE SUPPRESSION SYSTEM WITH ALARM, EXHAUST BLOWER ROTATION SENSOR, BASKET ROTATION SENSOR, TILT INTERLOCK SAFETY SWITCHES, DOOR SAFETY SWITCHES, GUARDS ON MOVING PARTS, TILT AND DOOR WARNING BELL, ELECTRICAL INTERLOCK TO PREVENT DOOR AND TILT MIS-OPERATION, DOOR OPENS ON POWER FAILURE, CIRCUIT BREAKER WITH MECHANICAL INTERLOCK TO PREVENT ELECTRICAL PANEL WITH POWER ON, THERMAL OVERLOAD PROTECTION DEVICES FOR ALL MOTORS, BOTH HANDS REQUIRED TO CLOSE DOORS, MANUAL FIRE PREVENTION SYSTEM SWITCH WITH GUARD TO PREVENT ACCIDENTAL ACTIVATION, BELL AND LIGHT TO INDICATE END OF CYCLE, AND MOMENTARY BASKET SWITCH. COST SHALL ALSO INCLUDE FREIGHT. THIS QUOTATION IS FOR THE PURCHASE OF A DRYER ONLY. THE GOVERNMENT WILL INSTALL. THE QUOTATION WILL BE AVAILABE ON OR AFTER 3/13/03, AND WILL BE DISTRIBUTED SOLELY THROUGH THE GENERAL SERVICE'S ADMINISTRATION FEDERAL BUSINESS OPPORTUNITIES WEB SITE HTTP://WWW.FEDBIZOPPS.GOV/. THE SITE PROVIDES DOWNLOADING INSTRUCTIONS. ALL FUTURE INFORMATION ABOUT THIS ACQUISITION, INCLUING QUOTATION AMENDMENTS, WILL ALSO BE DISTRIBUTED SOLELY THROUGH THIS SITE. INTERESTED PARTIES ARE RESPONSBILE FOR MONITORING THIS SITE TO ENSURE THAT THEY HAVE THE MOST UP-TO-DATE INFORMATION ABOUT THIS ACQUISITION.