The National Mine Health and Safety Academy, USDOL/Mine Safety and Health Administration is soliciting quotes for the following scope of work to be performed in Room D-203, 1301 Airport Road, Beaver, WV 25813.Furnish all labor and materials to fabricate and install new flashing around four (4) windows in Room 203. Remove existing windows, caulking, and flashing. Remove approximately 1-1/2?of foam insulation from the inside of the pack panel on the sides of windows and install 2?x4? wood board. Install new brown .042 metal flashing to cap the inside furring strips and lapping through the wall to the outside. Install brown metal on the bottom in the same fashion as the side flashings. Install new brown metal at the top of the window opening in the same fashion as the sides and the bottom, except when installing the flashing behind the outside skin along with the drip edge flashing. Install the existing window back into position, screwing through the window frame into the wooden frame. Install brown flashing to seal against the window facing and out over the pack panel, fastening the flashing to the window only to allow for expansion and contraction. All caulking will be butyle caulking. ALL VENDORS MUST BE REGISTERED ON THE CENTRAL CONTRACTING REGISTER (CCR). VENDOR MUST PROVIDE DUN AND BRADSTREET AND TAX IDENTIFICATION NUMBER. AN ONSITE VISIT IS SCHEDULED FOR JULY 10, 2007, AT 10:00 AM EASTERN DAYLIGHT SAVINGS TIME. PLEASE CONTACT GARY HUMPHYEY AT 304-256-3481 TO SCHEDULE ATTENDANCE BY YOU OR YOUR COMPANY REPRESENTATIVE. ANY QUESTIONS AFTER SITE VISIT MUST BE ADDRESSED BY EMAIL TO
[email protected] OR FAX TO 304-256-3350 BY THURSDAY, JULY 12, 2007, 3:00 PM EASTERN DAYLIGHT SAVINGS TIME. NO PHONE CALLS WILL BE ACCEPTED. QUOTES MAY BE SUBMITTED BY EMAIL TO
[email protected] OR FAX TO 304-256-3350 AND ARE DUE BY CLOSE OF BUSINESS JULY 17, 2007.