(i) This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in FAR subpart 12.6, as supplemented with additional information included in this notice. This announcement constitutes the only solicitation; proposals are being requested and a written solicitation will not be issued. (ii)The solicitation number N68335-15-C-0137 is being issued as a limited competition. All contractors seeking award must be a small business authorized and licensed by Boeing to sell the support equipment listed below in section (v) to the Government in support of the P-8A aircraft. (iii)The solicitation and incorporated provisions and clauses are in effect through Federal Acquisition Circular 05-66. (iv)This solicitation is being issued on a limited competition basis as stated in paragraph (ii). The North American Industrial Classification System (NAICS) code for this procurement is 336413. (v)The Contract Line Item Numbers (CLINs) are firm-fixed price (FFP) and are listed as follows: CLIN 0001: Control Wheel Straight Edge, Part Number SE27-0001, Quantity 2 Each, NSN 4920-01-020-8475. CLIN 0002: O-Ring Installation Tool, Part Number ST848, Quantity 2 Each, NSN 5120-01-582-2336. CLIN 0003: Pin Alignment Bolt Installation, Part Number ST9501B, Quantity 2 Each, NSN 4920-01-610-4818. CLIN 0004: Pitot Static Cover Inst/Rem Tool, Part Number A10002-7, Quantity 3 Each, NSN 5120-01-472-6224. CLIN 0005: Switch Proximity, Part Number A27092-106, Quantity 4 Each, NSN 5930-01-581-8715. CLIN 0006: Lift Fixture-Engine Accessory, Part Number A71015-108, Quantity 4 Each, NSN 4920-01-543-7570. CLIN 0007: Lock Equipment, T/R, Part Number B78009-26, Quantity 2 Each, NSN 4920-01-471-0203. CLIN 0008: Wing Jack Adapter, Part Number C07002-1, Quantity 3 Each, NSN 1730-01-469-6211. CLIN 0009: Fitting Assy Aircraft Tie down, Part Number C07005-1, Quantity 1 Each, NSN 1730-01-468-8880. CLIN 0010: Adapter Assembly, Cable Breakout, Part Number C22005-25, Quantity 2 Each, NSN 4920-01-580-6927. CLIN 0011: Set, Lock Outboard Ground Spoiler, Part Number C27001-42, Quantity 6 Each, NSN 1730-01-604-7415. CLIN 0012: Set, Clamp Trailing Edge Flap Torq., Part Number C27022-1, Quantity 4 Each, NSN 4920-01-469-6247. CLIN 0013: Pin, Lockout Depressurization Valve, Part Number C27038-6, Quantity 8 Each, NSN 1730-01-580-9111. CLIN 0014: Set Lock Flight Spoiler Actuator, Part Number C27047-41, Quantity of 4 Each, NSN 1730-01-587-0549. CLIN 0015: Set, Tool MLG + NLG Wheel Ret Nut, Part Number C32012-12, Quantity of 8 Each, NSN 5120-01-580-9431. CLIN 0016: Set, Thread Protector MLG, Part Number C32022-17, Quantity 8 Each, NSN 5365-01-581-2083. CLIN 0017: Set, Thread Protector NLG, Part Number C32022-20, Quantity 8 Each, NSN 1730-01-581-6170. CLIN 0018: Pin, Inserter and Remover, Part Number C32035-1, Quantity 1 Each, NSN 5120-01-581-7198. CLIN 0019: Test Equipment Engine Bleed Air Systems, Part Number C36001-64, Quantity 4 Each, NSN 4920-01-620-4677. CLIN 0020: Hold Open Equipment, T/R Cowl, Part Number C78019-15, Quantity 4 Each, NSN 4920-01-492-4560. CLIN 0021: Hold Open Equipment, 65 DEG T/R CO, Part Number C78021-1, Quantity 2 Each, NSN 1730-01-471-6723. CLIN 0022: Wrench Assy Door Handle Mechan., Part Number F70038, Quantity 2 Each, NSN 5120-00-165-2401. CLIN 0023: Wrench Assy, Pinion Gear, Part Number F71267, Quantity 2 Each, NSN 5120-00-571-3572. CLIN 0024: Protractor Mount used with Multipurpose Protractor, Part Number F72790, Quantity 2 Each, NSN 4920-00-586-6044. CLIN 0025: Regulator Air Pressure Elev Feel, Part Number F72928-58, Quantity 4 Each, NSN 4820-01-471-0194. CLIN 0026: Door Lube Set, Part Number F72942-1, Quantity 1 Each, NSN 4930-01-468-8745. CLIN 0027: Lock, Ground TE Flap Bypass Valve, Part Number F80049-46, Quantity 4 Each, NSN 1730-00-422-4139. CLIN 0028: Assembly, Trammel Bar Stab Trim, Part Number F80055-1, Quantity 2 Each, NSN 5120-01-469-1758. CLIN 0029: Fixture, Test Fuel Surge Pressure, Part Number F80166-1, Quantity 2 Each, NSN 4920-01-469-8478. CLIN 0030: Load Positioner, Part Number J20002-59, Quantity 4 Each, NSN 1740-01-618-3362. Award will be made to the lowest price, responsive, responsible offeror conforming to the RFQ. (vi)Only new items may be offered. Reconditioned or used items will not be accepted. (vii)Inspection and Acceptance is at Origin. (viii)Units are to be shipped FOB Destination to Lakehurst, NJ (full address to be provided at time of award). The Contractor shall preserve and package all hardware in accordance with best commercial practices for long-term preservation. All unit and exterior container/packs shall as a minimum be marked with the following information: Nomenclature: Serial number: Government contract or purchase order number: Contractor's name and address: National Stock Number: Packaging, Handling, Storage and Transportation: The Contractor shall pack and ship the items using best commercial practices and ship any approved traceable conventional mode of transportation. Handling of the unit is not expected to pose any unusual problems. This unit will be shipped using best commercial practices for shipping within the continental United States. Identification Plate: The following information is required on the identification plate: Nomenclature: Part Number: National Stock Number: Cage Code of the Manufacture: TBD Serial number: TBD Government contract or purchase order number: (ix)Offerors must comply with the following commercial item terms and conditions, which are incorporated herein by reference: FAR 52.212-1, Instructions to Offerors - Commercial Items, applies to this acquisition. (x)FAR 52.212-2, Evaluation- Commercial Items is incorporated by reference. Addendum to FAR 52.212-2 Para (a): Award will be made to the lowest price, responsive, responsible offeror conforming to the RFQ. (xi)FAR 52.212-4, Contract Terms and Conditions - Commercial Items is incorporated by reference. The resulting contract will be firm- fixed price (FFP). (xii)FAR 52.215-5, Contract Terms and Conditions Required to Implement Statutes or Executive Orders- Commercial Items, applies to this acquisition and the following clauses apply: 52.203-6, Restrictions on Subcontractor Sales to the Government; 52.203-13, Contractor Code of Business Ethics and Conduct; 52.204.10, Reporting Executive Compensation and First-tier Subcontract Awards; 52.209-6, Protecting the Government's Interest When Subcontracting with Contractors Debarred, Suspended, or Proposed for Debarment; 52.222-35, Equal Opportunity for Veterans; 52.223-18, Encouraging Contractor Policies to Ban Text Messaging while Driving; 52.225-13,Restrictions on Certain Foreign Purchases; 52.226-5,Restrictions on Subcontracting Outside Disaster or Emergency Area; and 52.247-64, Preference for Privately Owned U.S. Flag Commercial Vessels. In addition to the above, the following FAR and DFARS clauses apply to this acquisition: 52.203-3, Gratuities; 52.204-7, System for Award Management; 52.225-25 Prohibition on Contracting with Entities Engaging in Certain Activities or Transactions Relating to Iran-Representation and Certifications; 52.246-2, Inspection of Supplies-Fixed Price; 52.247-34, F.O.B. Destination; 252.203-7000, Requirements Relating to Compensation of Former DoD Officials; 252.203-7002, Requirement to Inform Employees of Whistleblower Rights; 252.203-7005, Representation Relating to Compensation of Former DoD Officials; 252.204-7012, Safeguarding of Unclassified Controlled Technical Information; 252.209-7004, subcontracting With Firms That Are Owned or Controlled By The Government of a Country that is a State Sponsor of Terrorism; 252.225-7001, Buy American And Balance of Payments Program-Basic; 252.225-7012, Preference for Certain Domestic Commodities; 252.225-7015, Restriction on Acquisition of Hand or Measuring Tools; 252.225-7048, Export-Controlled Items; 252.232-7003, Electronic Submission of Payment Requests and Receiving Reports; 252.247-7023, Transportation of Supplies by Sea; 252.211-7003, Item Valuation and Identification and 252.232-7006, Wide Area WorkFlow Payment Instructions. (xiii)Additional requirements: Warranty. The offeror's commercial warranty of at least one year shall apply. (xiv)Offers shall be valid for 60 days. Offers are due not later than 8:00 AM EST, Monday, 1 June 2015, at the Naval Air Warfare Center Aircraft Division Lakehurst, Attn.: Code 25232CM, Cindy Mollo, Hwy 547, Bldg 120, Room 166, Lakehurst, NJ 08733-5082 OR
[email protected]. Questions regarding this combined synopsis/solicitation can be directed to Ms. Cindy Mollo, 732-323-7226, e-mail:
[email protected]. Hard copy of solicitation and amendments will NOT be mailed to contractors. Offerors must acquaint themselves with the new regulations concerning Commercial Item Acquisition contained at FAR Subpart 12 and must be registered in the System for Award Management (SAM). The full text of the referenced FAR clauses may be accessed electronically at http://www.acqnet.gov/far.